Spitfire Scout Scooter Flash Codes | EZ Able

Spitfire Scout Scooter Flash Codes: What Each One Means

Quick answer

Count the flashes on your Drive Medical Spitfire Scout, then match the number to the table below. Most codes point to a loose connection, a connected charger or a battery that needs charging, so check those first. For anything beyond these checks, contact Drive Medical's technical department.

Read the full guide: Spitfire Scout Mobility Scooter Error Codes

Spitfire Scout flash codes

Flash codePossible causeWhat to try
1The battery needs charging, or there is a bad connection to the battery.Check the battery connections. If they're good, charge the battery.
2Bad connection to the motor.Check all connections between the motor and the controller.
3The motor has a short circuit to a battery connection.Have the motor tested.
4Not used.—
5Not used.—
6The controller is being inhibited from driving.Check the battery charger connector, and disconnect the battery charger.
7Throttle control fault.Make sure the throttle is in the at-rest position before you switch the scooter on. Adjust it if needed.
8Controller fault.Make sure all connections are secure.
9Bad connection at the electromagnetic brake.Check the electromagnetic brake and motor connections, and make sure the controller connections are secure.
10Excess voltage applied to the controller.Check the battery connections. This is usually caused by a poor battery connection.

Before you call for service

  1. Turn the scooter off.
  2. Check every battery, motor, brake and controller connection and reseat anything loose.
  3. Unplug the battery charger. The scooter won't drive while the charger is connected (code 6).
  4. Charge the battery fully, then switch on with the throttle at rest and count the flashes again.

Good to know

EZ Able® doesn't provide mobility scooter troubleshooting or repair. For help with your scooter, contact the manufacturer. Drive Medical's technical department: (877) 224-0946. Drive Medical also posts troubleshooting information for its products at drivetech.info.

Common questions

What does a single flash mean on a Spitfire Scout?

Flash code 1 means the battery needs charging or there's a bad connection to the battery. Check the connections first, then charge the battery.

Why won't my scooter drive while it's plugged in?

Flash code 6 means the controller is being inhibited from driving. That usually happens when the battery charger is connected. Unplug the charger and try again.

Can EZ Able repair my mobility scooter?

No. We don't offer scooter troubleshooting or repair service. Contact your scooter's manufacturer. For Drive Medical, call its technical department at (877) 224-0946.

Do you have codes for other scooter brands?

No. This page covers the Drive Medical Spitfire Scout only. For other brands, check your owner's manual or contact the manufacturer.

Related help

Need a hand?

Call us at 877-392-2531, Monday–Friday, 9–5 Eastern. You can also open a support ticket or chat with Abby on ezable.com.